Gas-assisted Mold

In the early stage of design, it is necessary to pay attention to the setting of the gate position, as well as the setting of the air inlet position. The flow of both should be fully considered.

If not fully considered in the early stage, mold testing will be very difficult. And it is difficult to produce qualified products.

The handle product shown below is made of PP. Needle valve gates are used. However, due to the limitations of product requirements on the location of the air inlet, it is necessary to optimize the injection molding process and air blowing process to achieve product molding. Through various analyses, we ultimately produced qualified products.

If you need to learn more about gas assisted molding technology, you can contact us.